This command is used to list a route from the FWT table. This event is generated only once after. Use the -i option to retrieve version information from the driver. Disable auto rate adapt. The length and offset parameters allow dumping cer-. If you want to list all the routes in a.
|Date Added:||3 May 2008|
|File Size:||23.15 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Also note that this command is meant.
Set the weighting factor for calculating RSSI. Default is to dump the entire EEP. This event is generated when the average received RSSI in beacons goes.
This command is used to set the Tx rate, ack policy, and retry limit on a per packet basis. This command is used to set pre-TBTT time period where value is in microseconds. This command is used to list a neighbor from the FWT table.
en/users/Drivers/libertas – Linux Wireless
linuc Enables or disables automatic transmit power control. This command is used to get the best route in the FWT table to a given. The first parameter turns this feature on 1 or off 0. This command is available only when STA is connected.
The MESH commands are used to configure various features of the mesh. This event is generated only once after. Set the weighting factor for calculating SNR.
This command sets the data rates bitmap. The bssid and ssid fields, if blank. Use 0 for an indefinite entry. The options that can be sent are: This command is used to set the region code in the station.
There are no input parameters. The only parameter is the MAC address of the host that is being.
This command is used to get the ad-hoc Network Status. Libfrtas commands take two parameters that specify the offset. Value field specifies the consecutive failure count threshold which.
This command is used to set the listen interval in the. If you want to list all the routes in a. Maximum Number of LEDs are Set automatic frequency control options.
Linux source code: drivers/net/wireless/marvell/libertas/if_cs.c (v) – Bootlin
Disable auto rate adapt. If the dur or probes tokens are absent, the driver default. This command is used to control 11d.
This command sets the value of listen interval. This command is used to remove an entry to the FWT table. Data Rate Mbps — 1 2 5. Note that libertae indicies may change as the fwt is.